eTesta GPSCAN MK3 HAX
Introduction
Our latest CAN based GPS receiver that is much more than simple GPS. It is used for testing trains, tires, cars, rally cars, race motorcycles etc...
Main Features
Supported GPS Systems
20Hz GNSS with GPS+GALILEO+BEIDOU+QZSS systems. L1+L5
Construction
Lightweight but still strong, made to anodized aluminum casing. Weatherproof since potted.
Other advantage is that the cheap antenna is separate and the receiver itself can be installed into a safe location.
Compatibility
Compatible with any CAN system, we have DBC file available to make install simple and fast.
MoTeC Compatibility
Plug & Play with all MoTeC devices, M1 ECU, displays, loggers etc...
Main Differences to GPSCAN and GPSCAN MK2
| Feature | GPSCAN MK3 |
| GPS Output rate | 20Hz |
| GPS Pulse output | Optional |
| NMEA Output | No |
| MYLaps Emulation | Optional |
| 2D Output format | Optional |
| IMU Roll-Pitch-Yaw angles | No |
| IMU Angle Rates | No |
| Acceleration sensor | No |
| Gravity free Acceleration output | No |
| NED Velocities | No |
| Sensor Fusion | No |
| Interference Indication | No |
| Jamming Indication | No |
Technical Specification
| GPSCAN MK3 HAX | |
| Supported systems |
Any system supporting CAN bus, DBC available. Notice for MoTeC M1 customersWe only support Standard MoTeC GPS module. Contact us if you have your own message format or need custom format for your application. |
| GNSS systems |
L1 + L5Band, 20Hz: Concurrent GPS+GALILEO+BEIDOU+QZSS |
| Accuracy |
0.4m |
| Supported CAN types |
CAN 2.0b. (J1939 or NMEA 2000 is not supported) |
| CAN ID |
Default: 0x21C |
| CAN Speeds |
500k or 1Mbit. Default: 1Mbit/s |
| Operating voltage | 5-36V (Absolute Min 4.75V) |
| Current requirement | Minimum of 200mA is required |
| Current consumption (12V) |
Searching: 13mA GPS Fix: 15mA |
| LED | Blue |
| Construction | Potted |
| Material | Aluminum, anodized black |
| Weight | 67gr |
| Dimensions |
Variant 1: 61 x 21 x 13.3mm Variant 2: 51 x 21 x 10mm |
| Connector | Made to spec |
| Warranty |
1 year (Antenna excluded) |
Pinout and Wiring
| Pin | Signal | Wire color | Notes |
| 9 | GND | Black | |
| 10 | CAN - HI | White | 120ohm Terminating resistor is required |
| 11 | CAN - LO | Green | 120ohm Terminating resistor is required |
| 12 | Battery + | Red | 7-36V |
120ohm Terminating resistor is required for the CAN if not fitted.
Status Light
Led light indicates the status of the GPS.
| Led Status | |
| Power up | Led blinks once indicating power is connected. |
| Fast blinking | No GPS available, searching. |
| Number of satellites | Number of 500ms pulses after 1s pulse multiplied by 2. |
Documents
-
- TBD
Availability: Now, Contact us to reserve yours or for more details and pricing.