NEW: GPSCAN MK2 - up to 100Hz GPS receiver
GPSCAN SA/HA MK2- Up to 100Hz CAN GPS Receiver
GPSCAN
Our latest CAN based GPS receiver that is much more than simple GPS. It is used for testing trains, tires, cars, rally cars, race motorcycles etc...
GPSCAN can be built with very fast 100Hz GPS for applications needing the lowest possible latency. Our devices are used in many drag race motorcycles/cars and is used to control the launch and traction control systems. Check here how fast it is.
GPS
Device can be equipped with any GPS receiver, even a receiver with an accurate L5 band is available.
Construction
Lightweight but still strong, made to anodized aluminum casing. Weatherproof since potted.
Other advantage is that the cheap antenna is separate and the receiver itself can be installed into a safe location.
Compatibility
Compatible with any CAN system, we have DBC file available to make install simple and fast.
MoTeC Compatibility
Plug & Play with all MoTeC devices, M1 ECU, displays, loggers etc...
Pictures
Specification
GPSCAN | |
Supported systems |
Any system supporting CAN bus, DBC available. Notice for MoTeC M1 customersWe only support Standard MoTeC GPS module. Contact us if you have your own message format or need custom format for your application. |
GNSS systems |
100Hz: GPS 50Hz: GPS+GLONASS SA 25Hz: GPS+GLONASS+GALILEO+BEIDOU+QZSS HA 25Hz: GPS+GALILEO+BEIDOU |
Accuracy |
SA: 2m HA: <0.4m |
Supported Bands |
SA: L1 or HA: Multiple bands |
Output rates |
25Hz, 50 or 100Hz |
Supported CAN types |
CAN 2.0b. (J1939 or NMEA 2000 is not supported) |
CAN ID |
Default: 0x21C |
CAN Speeds |
500k or 1Mbit. Default: 1Mbit/s |
GPS Lean Angle | Yes |
MoTeC STC Emulation |
No |
Operating voltage | 7-32V |
Current requirement | Minimum of 200mA is required |
Current consumption (12V) |
Searching: 80mA GPS Fix: 75mA |
LED | Yellow (SA), Blue (HA), Red (50Hz), White (100Hz) |
Construction | Potted |
Material | Aluminum, anodized black |
Weight | 67gr |
Dimensions | 68 x 27 x 17mm |
Connector | Made to spec |
Warranty |
1 year (Antenna excluded) |
Pinout and Wiring
DTM Pin | Signal | Wire color | Notes |
1 | GND | Black | |
Optional - Serial TX | Blue | NMEA output | |
2 | CAN - Lo | Green | 120ohm Terminating resistor is required |
3 | CAN + Hi | White | 120ohm Terminating resistor is required |
4 | Battery + | Red | 7-32V |
JWPF | For Firmware updates |
120ohm Terminating resistor is required for the CAN if not fitted.
Status Light
Led light indicates the status of the GPS.
Led Status | |
Power up | Led blinks once indicating power is connected. |
Off | No GPS available, searching. |
Blinking 1/sec | 3D GPS Fix is available |
Documents
Availability: Now, Contact us to reserve yours or for more details and pricing.